Tutorial - Modeling Eye End (joint) in SolidWorks?

Here is the tutorial.
Step 1:
Start SolidWorks in part mode.
Step 2:
Front plane>>Sketch.
Step 3:
Draw two circles of 100mm and 50mm dia.
Step 4:
Extrude it mid-plane by 60mm.
Step 5:
Front plane>>sketch.
Step 6:
Draw a box like this one.
Step 7:
Same extrude operation.
Step 8:
Fillet.
Step 9:
Fillet these edges at 50mm.
Step 10:
Right face>>sketch.
Step 11:
Draw circles like this at each corner of 20mm.
Step 12:
Extrude cut 60mm.
Step 13:
Select this face and then sketch.
Step 14:
While selecting the face click convert entities.
Step 15:
Revolved cut.
Step 16:
Use the line as the axis.
Step 17:
Right face>>sketch.
Step 18:
Draw a circle of 50mm dia.
Step 19:
Extrude it by 50mm.
Step 20:
Again right face>>Sketch.
Step 21:
Convert the edge.
Step 22:
Extrude cut with flip side to cut at 60º draft.
Step 23:
Then fillet that edge by 10mm.
Step 24:
We have the part.